Test
Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Are the accessories in perfect condition?
-
Are all lines in perfect condition?
-
Is the feed unblocked?
- Are the ventilation slots clear and clean?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.
Storage
Winter storage
1. Switch the pump
off by pulling the power plug.
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Uninstall the connecting lines to the pool and drain the hoses.
4. Lift the pump and drain it via the two connections.
5. Drain the filter medium. To do so, carry out steps 3 to 11 in the "Exchanging the filter medium"
section.
If you are using filter balls, wash them by hand and let them dry completely. If you are using sand,
pour the sand into a suitable container (e.g. bucket) and store this in a dry place.
6. Rinse the filter system with tap water.
7. Let the filter system dry completely.
8. Press and hold down the valve lever
on the valve head
.
9. Turn the valve lever to the "WINTER" position and let go.
The device can be stored over the winter.
1. Store the device in a dry and frost-free location (>= +5 °C) without direct sunlight.
Troubleshooting
Problem Possible cause Remedy
The pressure on the manometer
exceeds 1 bar.
The quartz filter sand is dirty. Backflush the system (see section
"Backflushing").
The filter balls are dirty. Remove and wash the filter balls by hand.
Exchange the filter balls if necessary.
Air bubbles escape from the
injection nozzle.
The pump is sucking in air. Check all hoses and gaskets for leaks.
Retighten the hose clamps.
Check the water level in the pool and fill
with more water if necessary until the
pool water covers the suction line
connection completely.
32
To Next Page
Loading...
Need help?
General
