Problem Possible cause Remedy
The pump is not getting enough
water or the system pressure is too
low.
The water level in the pool is too
low.
Raise the water level in the pool.
The prefilter basket (if present)
is clogged.
Empty the prefilter basket.
The suction line is out of place
or clogged.
Clean the pressure line.
The pump does not start up. The pump has no power. Connect the pump's power plug to the
power supply. Check whether the fuse
has tripped.
The pump is defective. Contact customer service.
There is filter medium in the pool Quartz filter sand was topped
up.
Backflush the system until the water runs
clear. See section "Backflushing".
Defective screens in the filter
vessel.
Check the screens for damage and
replace if necessary.
If the problem cannot be solved, contact the customer service listed on the last page.
Technical data
Model: 040385 Pump model: CPS 40-2
Item number: 040385GH (black)
040385GH1 (gray)
040385GM (mint green)
040385GP (blue)
040385GW (wine red)
Pump item number: 040955
Vessel volume: Ø 250 mm / approx. 12 l Pump installation: on base plate
Connection diameter: Ø 32/38 mm Pump function principle: not self-priming
Design: 7-way valve with
manometer
Pump timer: - - - - -
Circulation rate: max. 3,900 l/h Battery for timer: - - - - -
Pool volume (water
content):
max. 19,000 l (10,000 gal) Prefilter: - - - - -
Water temperature: max. 35 °C Power supply: 220-240 V~, 50/60 Hz
Requirements on filter
medium:
Output: max. 200 W
Steinbach filter balls: approx. 300 g Flow rate: max. 4,500 l/h
Quartz filter sand: approx. 10 kg;
0,7-1.2 mm;
DIN EN 12904
Delivery head: max. 6.5 m
33
To Next Page
Loading...