Need help?Do you have a question about the Migatronic AUTOMIG and is the answer not in the manual?
Key safety precautions for arc welding and cutting operations, including electricity, light, smoke, fire, and noise hazards.
Guidelines for reducing electromagnetic disturbances during welding operations and considerations for the surrounding area.
Explanation of 2-times, Spot, Stitch, and 4-times welding modes controlled by the switch.
Controls for adjusting welding time, pause time, burn-back, and wire feed speed.
Solutions for wire feed issues, including alignment, taut wire reels, and worn parts.
Key safety precautions for arc welding and cutting operations, including electricity, light, smoke, fire, and noise hazards.
Guidelines for reducing electromagnetic disturbances during welding operations and considerations for the surrounding area.
Explanation of 2-times, Spot, Stitch, and 4-times welding modes controlled by the switch.
Controls for adjusting welding time, pause time, burn-back, and wire feed speed.
Solutions for wire feed issues, including alignment, taut wire reels, and worn parts.
General| Input Voltage | 3 x 400 V |
|---|---|
| Power Supply | 3-phase |
| Type | MIG/MAG |
| Mains Fuse | 16 A |
| Wire Dimension | 1.2 mm |
| Standards | EN 60974-1, EN 60974-10 |
To Next Page
