(4) Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle
(rope will pull slightly harder at this point). Let the rope rewind slowly.
(5) Pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle. Let rope
rewind slowly. Do not let starter handle snap back against starter.
(6) Repeat procedure until engine fires. When engine starts, move choke lever on engine halfway
between CHOKE and RUN.
NOTE: If engine does not fire after three attempts, move choke lever halfway between CHOKE and RUN
position and try again.
(7) Move throttle control to IDLE position for a few minutes warm-up. Move choke lever to RUN
position as engine warms up.
(8) Put the throttle in the FAST position or wide open when chipping or shredding.
TO STOP ENGINE
(1) Move throttle control lever to STOP position.
(2) Disconnect spark plug wire and move away from spark plug to prevent accidental starting while
equipment is unattended.
HOW TO USE YOUR LEAF SHREDDER-CHIPPER
The leaf shredder-chipper is designed for three different methods of operation:
Lh
WARNING: THE LEAF SHREDDER-CHIPPER DISCHARGES MATERIALS WITH
CONSIDERABLE VELOCITY. KEEP AWAY FROM THE AREA AROUND THE
DISCHARGE COVER. ALWAYS STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE WHEN REMOVING OR ATTACHING THE BAG, WHEN
CHANGING CONTAINERS, OR WHEN REMOVING THE SHREDDED MATERIAL.
WEAR SAFETY GLASSES AND GLOVES WHENEVER USING YOUR LEAF
SHREDDER-CHI PPER.
Leaves and small branches can be fed into the hopper assembly when it is in the upright or lowered
position. See figure 6. If it becomes necessary to push material into the leaf shredder-chipper, use a
small diameter stick - NOT YOUR HANDS. The stick should be small enough that it will be ground up
if it gets into the tri-Iobe blade assembly.
Figure 6
10
To Next Page
Loading...
