WARNING: DO NOT DEPOSIT MATERIAL LARGER THAN 1/2" DIAMETER IN
THE HOPPER
ASSEMBLY.
ANY
MATERIAL HEAVIER THAN
1/2" SHOULD BE
FED INTO THE CHIPPER CHUTE.
Leaves and small twigs can be raked into the hopper assembly when the machine is in the lowered
position. See figure 7. Small branches can also be fed into the hopper assembly in this position. See
figure
8.
Figure
7~
Figure 8
To lower the hopper assembly, grasp the handles at the top of the hopper assembly and push forward
and down. The kick stand will automatically fold up and out of the way. Rest the hopper on the ground.
Bulky material, such
asstalks
or heavy branches (i:iriYthin~fover-1/2"
diameter,
upto
2"-indianieter-for
the LSC503, and 3" for the LSC505 and LSC508), should be fed into the chipper chute. See figure 9.
DO NOT USE THE CHIPPER TUBE WHEN UNIT IS IN THE DOWN POSITION!
Figure 9
IMPORTANT: There is a screen located inside the housing in the discharge area. If the screen becomes
clogged, stop the machine, disconnect the spark plug wire from the spark plug, and remove and clean
as instructed in the Maintenance section on page 12.
11
To Next Page
Loading...
