Welcome to VBar EVO!
VBar EVO is an innovative product setting new standards for
model helicopters in terms of ight performance and program-
ming capacity.
Features:
• Easy setup and ne adjustments can be done with
any VBar Control radio.
• Ready for online updates as they become available.
• Built-in Governor for electric model helicopters
(IC powered models require the Pro rmware).
• Fully compatible with VBar Control. For setup
using VBar control, please refer to your VBar
Control manual or to online help in VBar Con-
trol EVO/Touch.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the
interference at his own expense.
Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the device.
The antenna(s) used for this transmitter must be installed to provide a separation distance of
at least 20 cm / 7.87 in from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users must be provided with transmitter operating
conditions for satisfying RF exposure compliance.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC ID 2ABXHVBCRX30
To Next Page
Loading...
General