Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will
now look for a CAPsMAN server (total of 10 seconds).
Or Keep holding the button for 5 more seconds until the LED turns off, then release it to make the
RouterBOARD look for Netinstall servers (total 15 seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button
is pressed before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Netinstall
When performing Netinstall, make sure to use the latest v7 version of both RouterOS with the
additional package wifiwave2-x.x-arm64.npk must be installed files and the Netinstall software.
Accessories
The package includes the following accessories that come with the device:
ADAPT1_ EU/US Switching Power Supply 24V, 1.2A.
CAB3_ CAT5E UTP Flat Cable, 8P8C, AWG32, 1.5m.
Antenna usage
External antenna sockets are located on the back of the device. Device comes with connected wireless
antennas, LTE antennas are not provided within the package.
Operating system support
The device supports RouterOS software version v7. The specific factory-installed version number is
indicated in the RouterOS menu /system resource. Other operating systems have not been tested.
To avoid pollution of the environment, please separate the device from household waste and dispose of
it in a safe manner, such as in designated waste disposal sites. Familiarize yourself with the procedures
for the proper transportation of the equipment to the designated disposal sites in your area.