2.Connect PoE adapter to the PC or other network device by using the adapter Ethernet cable marked
DATA;
3.Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Mounting
1.Slide the included metallic mounting rings into the two slots on the back of the antenna dish.
2.Attach the unit to a pole, with the Ethernet port pointing downward.
3.Use a PH2 screwdriver to tighten the rings.
4.Fix the Ethernet cable to the pole using zip ties, less than one meter from the unit, to avoid the cable
being pulled out of the port.
5.Check mounting angle and positioning.
To Next Page
Loading...
Need help?
General
