MikroTik netPower 16P User Manual

portwilldependontheincomingtothedevice.
MaxPoE-outonlow(<30V)voltage5.6A(2.8Aper8portgroup,max1.1Aperport).
MaxPoE-outonhigh(>30V)voltage2.8A(1.4Aper8portgroup,max0.6Aperport).
ConnectingtoaPoEAdapter,onlytodeliverpowertootherdevices:
1. ConnecttheEthernetcablefromthedevicetothePoE+DATAportofthePoEadapter.
2. ConnectanEthernetcablefromyourlocalnetwork(LAN)tothePoEadapter.
3. Connectthepowercordtotheadapter,andthenplugthepowercordintoapoweroutlet.
BottomLid
1. Bottomlidissecuredinplacewiththecaptivescrew,itcanbeunscrewedbyhand,butdonotremovethescrewcompletely.
2. Pullthecovertowards.
3. LifttoaccessEthernetports.
Mounting
Thedevicecanbemountedinseveralways:pole,wall,orceiling.Thepackagealsoincludesadrillholetemplatewithdetailedmountinginstructions,tohelpyouwiththedrill
holemarking.Thedevicehaseightmountingpointsforversatilityuseziptiesorsteelclampsformountingonthepole.

Mountingpoints:
Thereareeightmountingpointsonthebackofthisdevice.Choosethemostrelevantones.
Middlepointsaredesignedformountingonthemast,therearecurvesonthecaseforslimfitment.
ThedevicemustbemountedbyUParrowfacingupwards.
Attachyourgroundingwiretothegroundingscrew.
WhenusingboththehighandlowVoltageadapters,thenetPowerwillautomaticallychoosethecorrectPoEstandardandVoltage,basedonthedevicesyou
connecttoeachport.Thiscanalsobespecifiedmanually.
TheIPratingscaleforthisdeviceisIP54.Whenmountingoutdoors,pleaseensurethatanycableopeningsaredirecteddownwards.
It'srecommendedtosecureEthernetcabletothepoleusingzipties.Withthedistancefromthedeviceapproximately30cm.
Theinstallationinfrastructure(towersandmasts),aswellastherouteritself,mustbeproperlygrounded.Thedeviceincludesagroundingwireattachmentscrewon
thebackside.

MikroTik netPower 16P Specifications

General

Switch type	-
Switch layer	L2/L3
Flash memory	16 MB
Internal memory	256 MB
Processor model	98DX226S
Built-in processor	Yes
Processor frequency	800 MHz
Operating temperature (T-T)	-40 - 70 °C
Power connector	DC-in jack
SFP+ module slots quantity	2
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
DC input voltage	18 - 57 V
Power consumption (max)	316 W
10G support	No
Networking standards	IEEE 802.3af, IEEE 802.3at
Certification	CE/RED, EAC, RoHS
Product color	White
Forwarding rate	53.6 Mpps
MAC address table	- entries

Weight and Dimensions

Depth	78 mm
Width	212 mm
Height	303 mm