MikroTik netPower 16P User Manual (English)

To Next Page

netPower 16P

netPower 16P (CRS318-16P-2S+OUT)

The netPower is a weatherproof switch with the capability of delivering PoE to your connected devices.

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

The Installation of the equipment must comply with local and national electrical codes.

This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the

correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.

Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.

Read the installation instructions before connecting the system to the power source.

We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your

own risk!

In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik devices must be professionally installed.

Quickstart

Please follow these quick steps to set up your device:

Open the bottom lid (see " ");Bottom Lid

Connect all served devices to Ethernet ports;

Connect the device to the power source (see " ");Powering

Once connected to the same network, open in your web browser to start configuration, user name: a and there is no https://192.168.88.1

dmin

password by default;

Once connected configure the device, so it has an active Internet connection ;https://mt.lv/configuration

Upgrade the RouterOS software to the latest version ;https://mt.lv/upgrade

Set up your router password in the bottom field of the QuickSet menu, to the right and repeat it, it will be used to login next time.

Expansion slots and ports

Other manuals for MikroTik netPower 16P

User Manual6 pages

Need help?

Do you have a question about the MikroTik netPower 16P and is the answer not in the manual?

MikroTik netPower 16P Specifications

General

Switch type	-
Switch layer	L2/L3
Flash memory	16 MB
Internal memory	256 MB
Processor model	98DX226S
Built-in processor	Yes
Processor frequency	800 MHz
Operating temperature (T-T)	-40 - 70 °C
Power connector	DC-in jack
SFP+ module slots quantity	2
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
DC input voltage	18 - 57 V
Power consumption (max)	316 W
10G support	No
Networking standards	IEEE 802.3af, IEEE 802.3at
Certification	CE/RED, EAC, RoHS
Product color	White
Forwarding rate	53.6 Mpps
MAC address table	- entries