16 17
children
Usage
a
b
c
d
e
f
Turn the ignition off.
Plug the charge into the vehicle’s charging port.
Plug the power plug into 110V/220V/250V local AC power supply.
The green light turns to red to indicate charging status.
After 6-8 hours charging, the red light turns to green to indicate the battery charging is finished.
While the charging is finished, the charger will cut off power from AC power supply automatically.
Instruction
06 THE MANUAL OF SMART CHARGER
The charger should be matched with the alternating voltage of local power supply before connecting charger.
1
The charger is designed & tested for original battery from manufacturer. Do not use them for the other
mismatching batteries.
2
The charger is tested & matched with its scooter. If the charger is used on other scooters, it might make
different charging effect and/or cause battery damage.
3
Please connect charger and scooter before connect to local power supply, while you are going to charge
the battery. Please disconnect the charger from local power supply while the battery is fully charged. Don't
disconnect charger and scooter while the charger is connected with local power supply for safety reason.
4
Do not violently shake the charger. It might cause damage of the charger.
5
Keep the charger away from any water, dust or high temperature.
6
The charger creates heat while working. It should be stored in well ventilated place and keep away from any
inflammable things.
7
Keep it away from children.
8
If any wire or shell was broken, please send it to the professional repairing service. Don't open or repair
it yourself. This action will cause danger and lose warranty of the charger.
9
The charger is designed and made for electric scooter battery charging use. Don't make it for other use.
10
Any incorrect usage which does not follow this instruction will lose guarantee from seller.
11
DESIGNED BY MIKU TEAM DESIGNED BY MIKU TEAM
To Next Page
Loading...