MIL'S MVX 2 - Running Operation; First Step; Switching on; Cleaning and Maintenance

Particular maintenance instructions
AIRMIL'S G with SCREW compressors
Regulation by MILLENIUM control device

Page 15/20 08/2017 Manual N° 515910 version 12
SECTION 6. RUNNING OPERATION
6.1. First step
⇒ 9!7!+ '
⇒ O -!(6 !-!!
2#6.K$%&)69)6'''4'
⇒ !KK #!K2K 4'
6.2. Switching on
⇒  !   #!  ! N%N  2K4  !  NN6 !  NN ' 9!7
) !     !  2  ! 4' %  &  -6  !
#!!-)"#!#'
⇒ !NN'
⇒ %! +6#!!+#;"""
!'
⇒ -! -#!!!'
⇒ !7! !-*
  !#76
 97!)#-!6
  !!76! !++'
SECTION 7. CLEANING AND MAINTENANCE
IMPORTANT:
For this operation, use all necessary protective measures (gloves, mask, overalls etc.) then
destroy contaminated consumables (antibacterial cartridges, condensates etc.) in according with
that country’s applicable laws (regulation incinerator).

Maintenance is to be entrusted to trained and approved personnel by the exploiting, with all
necessary knowledge and acquainted with best practice.

Not to carry out maintenance operations when the device is in use.

If the spare parts used during maintenance operations are not corresponding to the
manufacturers' requirements, the manufacturer declines all responsibility in the event of an
incident.
The modification of the central units is forbidden.

Modification of the device is forbidden without the approval of the manufacturer.

If the central is modified following manufacturer agreement, a control and a suitable test must be
realized to make sure that the central is always safe to use.