User Manual
www.milesight.com
32
Figure 4-11
Audio
Parameters Function Introduction
Enable Audio Check on the checkbox to enable audio feature
Audio Mode Enable audio input/output
Audio Input
Denoise:Set it as On/Off.When you set the function on the noise detected can
be filtered
Encoding:G711-Ulaw,G711-Alaw and AAC LC are selectable.
Input Gain:Input audio gain level ,0-100
Alarm Level:Alarm will be triggered if voice alarm is enabled and input gained
volume is higher than the alarm level,0-100
Output Volume The volume of alarm audio output
Note: The Audio mode and audio output is only for certain modules.
4.3.4 Network
Figure 4-12
To Next Page
Loading...
