EN 6 millheat.com
Assembly
1. Insert both legs into the brackets so you get a stable foot (as shown in Picture 1 below).
2. Aach the legs to the brackets by ghtening 2 screws into each bracket (see the picture below).
3. Remove the pre-mounted screws from the boom of the heater and place the heater gently on its head to mount
the feet.
4. Two screws must be fastened on each foot bracket (as shown in Picture 2 below).
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
To Next Page
Loading...
