8
EN
Day- and nighttime setback
When programming the heater for either day- or nighttime setback, the setback period
will be active from the time you register the program. Which means; if you want to start
your daytime setback at 7.30 am, you need to register the program at 7.30 am.
You only need to program the heater 1 time for daytime setback and 1 time for nighttime
setback. If you have programmed the heater, the setback programs will be active on the
following days:
Daytime setback: Monday-Friday (day 1-5)
Nighttime setback: All nights
EXAMPLE:
Let us say you want to program the heater for both daytime- and nighttime setback
(normally the heater is set to 23 degrees). You want the heater to do the following:
1. Daytime setback activated from 7.30 am to 2.30 pm. Desired temperature: 17 degrees
2. Nighttime setback activated from 10.00 pm to 6.00 am. Desired temperature: 18
degrees
How to activate daytime setback
1. Tuesday 7.30 am you go to the heater and press on the heater’s control panel.
2. “d” will be visible in the display. Use the wheel to set what day it is today when you are
programming the heater (1= Monday, 2 = Tuesday etc.) You are not programming
the heater for the various days. This is simply to tell the heater what day it is when you
are programming the heater, since the daytime setback is active only Monday-Friday.
Select 2 for Tuesday. Conrm by pressing .
3. “C” will ash in the display. Use the wheel to set 17 as the desired temperature for
daytime setback. Conrm by pressing .
4. “H” will ash in the display. Use the wheel to set 7 hours as desired setback period
(meaning it will be active from 7.30 am to 2:30 pm). Conrm by pressing .
5. The daytime setback will now be active from 7.30 am to 2:30 pm Monday-Friday.
Setback temperature is 17 degrees.
* Control light is green when the heater is in an active setback period. The control
light is red when the setback period is inactive but programmed.
See gure 10 on separate illustration sheet
To Next Page
