7
millheat.com
EN
Power indicator for day/night thermostat
When the panel heater is using power (i.e. when it is heating), the power indicator is lit .
Set desired temperature for day/night thermostat
Press the arrow buttons to set the desired temperature.
Instructions day/night thermostat
Control panel
Se gure 8 on separate illustration sheet
1. Display (shows the desired room temperature by default)
2. Control light – night function
3. Control light – day function
4. Power indicator – Shows whether the heater is using power or not
5. Control button (+) (Increase temperature)
6. Control button (–) (Reduce temperature)
7. Night function
8. Day function
9. Function button
TIP! The thermostat can be used as a regular electronic thermostat (i.e. the heater will
maintain a constant temperature 24 hours a day). Please see the section instructions
electronic thermostat for further information.
ATTENTION! Aer a power cut the thermostat will return to the last registered temperature.
WARNING: BEFORE THE HEATER IS TURNED ON, IT MUST BE ATTACHED TO A WALL. IF THE
HEATER IS NOT INSTALLED CORRECTLY OR IS INSTALLED ASKEW, THIS MAY CAUSE THE
HEATER TO MALFUNCTION OR IN THE WORST CASE, BE DAMAGED.
If the temperature sensor is not functioning properly, you will see this symbol
on the display. Please contact the dealer or importer.
See gure 9 on separate illustration sheet
See gure 7 on separate illustration sheet
Please see table on page 4 for which models that have day- and night thermostats.
To Next Page
Loading...
