6
EN
Power indicator for electronic thermostat
When the panel heater is using power (i.e. when it is heating), the power indicator is lit .
Set desired temperature for electronic thermostat
Press the arrow buttons to set the desired temperature.
Instructions electronic thermostat
Please see table on page 4 for which models that have electronic thermostats
Control panel
See gure 5 on separate illustration sheet
1. Display (shows the desired room temperature by default)
2. Power indicator — shows whether the heater is using power or not
3. Control button (+) (increase temperature)
4. Control button (–) (reduce temperature)
5. Function button (F)
ATTENTION! Aer a power cut the thermostat will return to the last registered temperature
WARNING: BEFORE THE HEATER IS TURNED ON, IT MUST BE ATTACHED TO A WALL. IF THE
HEATER IS NOT INSTALLED CORRECTLY OR IS INSTALLED ASKEW, THIS MAY CAUSE THE
HEATER TO MALFUNCTION OR IN THE WORST CASE, BE DAMAGED.
If the temperature sensor is not functioning properly, you will see this symbol
on the display. Please contact the dealer or importer.
Resetting the heater
Turn o the heater's main switch. Press and hold while you turn on the heater's main
switch.
Memory function
The heater remembers all the temperature settings and will automatically return to the
desired temperature aer a power cut. Your day- and nighttime setbacks will however be
deleted aer a power cut, and you will need to register the programs again.
See gure 4 on separate illustration sheet
See gure 6 on separate illustration sheet
See gure 7 on separate illustration sheet
To Next Page
Loading...
