Millenium MPS-500 USB - Installation and Connectivity; Initial Setup and Power Connection

4 Installation
Rack setup and assembly of the pads and pedals are described in detail in the enclosed set
assembly guide. Finally check that all cables between the pads and the drum module have
been properly connected.
Connect the supplied D-sub plug of the pad connector cable to the D-sub input socket on the
rear panel of the drum module.
Connect the included power supply unit to the POWER input on the rear panel of the drum
module and then put the power plug into the power outlet.
Rack setup, connecting pads
and pedals
Connecting the pads
Connecting the power adapter
Installation
MPS-500 USB
15