Miller RFCS-5 - Table of Contents

TABLE OF CONTENTS
SECTION 1 − INSTALLATION AND OPERATION 1...............................................
1-1. Safety Symbol Definitions 1.............................................................
1-2. Software Licensing Agreement 1.........................................................
1-3. Information About Default Weld Parameters And Settings 1...................................
1-4. Typical Connection 2..................................................................
1-5. Remote Amperage Control For Welding Power Source Without
Remote Control Switch 2...............................................................
1-6. Remote Amperage Control For Welding Power Source With Remote Control Switch
But Without Output (Contactor) Control 3..................................................
1-7. Remote Amperage Control For Welding Power Source With Remote Control Switch
And Output (Contactor) Control 4.........................................................
1-8. Adjusting Potentiometer Timing 5.........................................................
1-9. Changing Cord Location On RFCS-5HD, RFCS−6MHD, And RFCS-14HD Models 5..............
SECTION 2 − ELECTRICAL DIAGRAMS 6......................................................
SECTION 3 − PARTS LIST 7...................................................................
WARRANTY