Electrical Manual
VM16,17,24,25,30 Electronic Orient Spindle
SERVING YOUR METAL CUTTING NEEDS FOR MORE THAN 25 YEARS
History
4-21-99 Original Version
6-3-99 Update electrical drawings to rev D (reactors added).
7-12-99 Rev2 Added front panel drawings and SGDB15 drive parameters
7-28-99 Rev3 Added Auger / Flush circuit and updated mag panel drawing
10-29-99 Added remote hand controller
12-17-99 Rev 4 Updated chip flush / auger schematic to rev G.
1-31-00 Rev 5 Update to SBC card cage, add electrical safety caution
2-4-00 Rev6 Update to revE electrical schematics, ECO No. 4387
12-15-00 Rev 7 Update machine wiring and mag panel. Remove RHC
3-2-01 Rev 8 Update prints, electronic orient, single and dual speed
Updated spindle and axis drive parameters
4-10-01 Rev 9 Updated MC5 parameters for two-speed spindle systems
To Next Page
Loading...
Need help?
General
