Pellerin Milnor Corporation 25
Notices
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
Qualified Personnel Only
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
— Do not attempt to move, anchor, or remove restraints from the machine unless you are a rig-
ger or technician, as defined above.
Disclaimer
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
— Pellerin Milnor Corporation is not responsible for damage to the machine after it leaves
the factory. Pellerin Milnor Corporation strongly recommends that the consignee (usually the
owner/management) carefully inspect the machine in its protective wrapping before off-loading
and inspect the uncovered machine after off-loading. If damage occurred in transit, ensure that
the transportation company acknowledges the damage in writing. Submit a damage claim as soon
as possible.
Other Tasks
BNWUUI03.R04 0000257899 D.2 B.7 A.4 1/2/20 2:19 PM Released
— This document addresses common tasks that the rigger and technician will perform. Other
tasks, not explained here, can be needed. Information about other tasks is usually provided by the
dealer, the Milnor® Applications Engineering department, or the Milnor® Service department.
Examples are:
• Placement of the machine on a platform, such as for laundry cart clearance or to accommo-
date unusual drain conditions.
• Partial disassembly and reassembly, possible on some models, for movement through small
spaces.
Facility Prerequisites
BNWUUI03.R01 0000254786 D.2 B.7 B.4 1/2/20 2:19 PM Released
Required Condition Supporting Information
structural support See document BNUUUI01 “Vital Information About the Forces
Imparted to Supporting Structures by Laundering Machines”
which can be found in the installation manual and also at
https://milnor.sharefile.com/d-s8408ba617d244d98.
protected storage If the machine must be stored temporarily, it must be protected
from dampness and excessive temperatures.
access to the final location See the machine dimensional drawing, which can be found at the
end of the installation manual, for overall dimensions. Partial dis-
assembly is sometimes possible. Contact the Milnor
®
Service
department.
clearances for machine
movement and maintenance
See the dimensional drawing.
operational clearances Adequate clearance around controls and for movement of laundry
equipment such as carts. See the dimensional drawing.
Installation Procedures
To Next Page
Loading...
Need help?
General
