Need help?Do you have a question about the Milwaukee M12 FUEL 2505-20 and is the answer not in the manual?
Keep work area clean and well lit. Avoid explosive atmospheres and keep bystanders away.
Use correct plugs, avoid grounded surfaces, protect from water, and do not abuse cords.
Stay alert, use PPE, prevent unintentional starting, and remove keys before use.
Use the correct tool, maintain it, and store it properly away from children.
Recharge with specified charger, use only designated packs, and avoid shorting terminals.
Follow speed ratings, start slowly, apply pressure in line with the bit.
Use OSHA compliant dust extraction for dust-creating applications.
Use drill-only mode, start slowly, use sharp bits, clear chips, back workpiece.
Use drill-only mode, high-speed drills, center punch, lubricate, use coolant, back material.
Drill pilot holes, set torque/speed, use proper bit, apply firm pressure.
Push release buttons to remove; slide pack into body until latched.
Remove battery, select attachment, pull collar, snap onto spindle.
Remove battery, use spindle lock, open/close chuck jaws, secure bit.
Pull the trigger to check charge level; a flashing light indicates low charge.
Rotate torque selector collar to drill symbol or desired clutch setting.
Push speed selector to '1' for low speed or '2' for high speed.
Set button to forward, reverse, or lock; motor must stop before changing.
Use drill-only mode, start slowly, use sharp bits, clear chips, back workpiece.
Use drill-only mode, high-speed drills, center punch, lubricate, use coolant, back material.
Drill pilot holes, set torque/speed, use proper bit, apply firm pressure.
Keep tool clean, inspect for issues, and have it serviced by qualified personnel.
Clean vents and handles; use mild soap and damp cloth, avoid solvents.
Return the tool, battery pack, and charger to the nearest service center for repairs.
To Next Page
General