Flat Bit ……………………………………………….1-1/8″
Auger Bit…………………………………………………. 1″
Hole Saw ……………………………………………2-1/8″
Screws (dia.)…………………………………………. 1/4″
Cat. No……………………………………………. 2607-20
No Load RPM…………………………………Low 0 – 450
High 0 – 1800
BPM…………………………………………..Low 0 – 7200
High 0 – 28800
Steel ……………………………………………………… 1/2″
Wood
Flat Bit ……………………………………………….1-1/8″
Auger Bit…………………………………………………. 1″
Hole Saw ……………………………………………2-1/8″
Screws (dia.)…………………………………………. 1/4″
Masonry………………………………………………… 5/8″
FUNCTIONAL DESCRIPTION
1. Trigger
2. LED
3. Keyless chuck
4. Torque selector collar
5. Application selector collar (2607-20 only)
6. Side handle (not included)
7. Speed selector
8. Control switch
9. Handle
ASSEMBLY
WARNING Recharge only with the charger specified for the battery. For specific charging instructions, read the
operator’s manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons and pull the battery pack away from the tool.
WARNING Always remove battery pack before changing or removing accessories. To insert the battery, slide the
pack into the body of the tool. Make sure it latches securely into place.
WARNING Only use accessories specifically recommended for this tool. Others may be hazardous.
To reduce the risk of injury, always use a side handle when using a 9.0 Ah or higher capacity battery pack with this
tool. Always brace or hold securely. Ensure side handle is tightened securely before each use.
Installing the Side Handle
If your drill/driver did not come with a side handle, visit www.milwaukeetool.com for the appropriate accessory
handle.
1. To install the side handle, loosen the side handle grip until the hooks are far enough apart to fit into the slots on the
gear case ring. Position the side handle on the top, pointing to the left or right. Tighten the side handle grip until it is
secure.
2. To remove the side handle, loosen the side handle grip until the side handle can be removed. Reposition and
tighten securely.
OPERATION
WARNING To reduce the risk of injury, always wear proper eye protection marked to comply with ANSI Z87.1.
When working in dusty situations, wear appropriate respiratory protection or use an OSHA compliant dust extraction
solution.
Always remove battery pack before changing or removing accessories. Only use accessories specifically
recommended for this tool. Others may be hazardous.
Installing Bits
To Next Page
Loading...
