Mima MBC Series - Maintenance Work that Users Can Finish

18
1.11 When working under the forklift, the forklift should be supported by the bracket.
Warning!
Improper support, the forklift will tip over and hurt people. If the forklift does not have lifting
equipment or bracket support protection, it is forbidden to work under the forklift.
2 The Maintenance that Users Can Finish
2.1Routine maintenance and safety inspection.
2.1.1 It is the responsibility of the operator to carry out routine maintenance and inspection of the truck.
2.1.2 The forklift does not perform routine maintenance, which will affect the safety and reliability of the
forklift.
A serious accident occurred.
2.1.3 Check for problems or find faults should be repaired immediately and stopped.
2.2 Maintenance work completed within 1 day, 1 week and 1 month as indicated in the maintenance
table can be completed.
(show in section 4 Maintenance Table)
2.3 Other maintenance sections given in the table. It can only be done by our company's maintenance
personnel or our company's approved maintenance organization.
Parts Checking Point Check content
1 Joystick Check if it is functioning properly
2 Emergency reverse switch Check if it is functioning properly
3 Horn Check if it is functioning prop erly
4 Steering Check if it is functioning properly
5 Hydraulic device Check if it is functioning properly
6 Electricity meter Check if it is functioning properly
7 Hydraulic system Check the oil level and whether it leaks oil
8 Drive unit Check for abnormal noise and oil leakage
9 Electromagnetic clutch Check if it is working properly and if it is in poor contact
10 transmission Check if it is functioning properly
11 Wheel Check for damage, remove oil, metal debris
12 Frame Check for damage and remove oil
13 Battery Check the electrolyte level
14 Fork Check for deformation or cracks
15 Lifting device Check for damage and remove oil
16 Hydraulic cylinder Check for damage and oil leakage