Mima moon - First Steps; Assembling the Base; Assembling the Cylinder Cover; Assembling the Seat

7
FIRST STEPS
1. Assembling the base
Put the base of the chair on the oor, insert the
pneumac cylinder, aligning the widest end of the
cylinder with the corresponding groove at the base. Push
the cylinder down to make sure that it ts into place
properly.
2. Assembling the cylinder cover
Put the cylinder cover on and turn it around twice unl it
ts.
3. Assembling the seat
Insert the end of the seat frame in the cylinder and
push downwards with your body weight to make sure it
is secured on the cylinder. Li the seat and if the base
remains aached them the seat has been secured.
Make sure that the cylinder goes into the end of the seat
frame correctly.
4. Removing the high chair seat
Press the buon at the boom front of the
seat to release it.
Li it up and out, so that just the junior chair seat
remains.
5. Assembling the safety bar
Install the safety bar on the high chair seat. First, fasten it
on the side and then the screws underneath.
1
3
4
5
2
EN