MIMAKI CJV150-75/107 - Page 54

Mimaki Europe B.V.
Sign Graphics Products
FAQ, 2
54
# Questions Answers
10
Are the cutting accuracy and the throughput of CJV300/150
and CJV30 equivalent?
Cutting accuracy: Equivalent or better
Throughput: Depends on cutting data (Detailed info is prepared
separately.)
11
How to print Mimaki Metallic Color Collection?
Three types of Metallic Color Collections are stored in a folder of
RL6.
Please open the file from the folder and print as usual.
12
When printing metallic color, different media profiles can be
used for silver plate and color plate, if the resolution and
pass count are the same. (This was not possible before.)
Is this also the same when using white ink?
Yes, it is. When composing color plate and white plate, different
media profiles can be used for each, so please select the same
profile for both color plate and white plate.
13
From CJV300/150, media width is detected not by the
position of the pinch rollers at the both sizes,
but by the actual media width. Then, is it possible to cut
media out of the pinch rollers at the both sizes?
Yes, it is.
14
The adjustment of CJV30's P&C positioning accuracy is
difficult, while Roland has the simple adjustment method.
How is the CJV300 and CJV150?
There is an special adjustment pattern which is similar to Roland's
pattern to print through RL6.
15
Can the setting of P&C positioning accuracy be registered as
"Favorite"?
No, it cannot.
16
Can the pinch roller which is positioned out of media be
turned off automatically?
Yes, it can.
17
Should the Pen
-line sponge be used when preforming half
cut
?
Half cut can be performed by using Pen
-line rubber. However, to
prevent the blade from abrasion, the use of Pen
-line
sponge(Optional) is recommended.