MIMAKI CJV30-100 - Page 3

ii
Operation Flow ............................................................ 2-7
Turning the Power ON/OFF ........................................ 2-8
Turning the Power ON ..................................................2-8
Turning the Power OFF ................................................2-9
Installing Tools .......................................................... 2-10
When a Cutter Is Used ...............................................2-10
Exchanging tool ..........................................................2-13
How to Attach a Ballpoint pen .....................................2-14
Setting a Medium ...................................................... 2-15
Adjusting the Head Height ..........................................2-15
Adjusting the Position of the Pinch Roller According
to the State of a Medium .............................................2-17
Roll Stopper ................................................................2-22
Maximum Print Area/Cut Area ....................................2-23
Notes When Using Medium Holder ............................2-24
Setting a Roll Medium .................................................2-25
Take-up Device ...........................................................2-29
Setting a Leaf Medium ................................................2-31
When Changing the Origin .........................................2-33
Test Printing .............................................................. 2-35
Test Printing ................................................................2-35
Performing Head Cleaning .........................................2-36
Performing Media Correction and Dot Position
Correction ...................................................................2-36
Test Cutting ............................................................... 2-37
Preparing for the Heaters ......................................... 2-38
Changing the Temperature Settings for the Heaters ..2-38
Checking the Heater Temperature .............................2-39
Printing Data .............................................................. 2-40
Starting a Printing Operation ......................................2-40
Stopping a Printing Operation .....................................2-41
Deleting Received Data (Data Clear) .........................2-41
Data Cutting ............................................................... 2-42
Starting a Cutting Operation .......................................2-42
Stopping cutting in a while ..........................................2-42
Restarting a Cutting Operation ...................................2-42
Stopping a Cutting Operation (Data Clear) .................2-43
Removing the Cutter Unit Temporarily .......................2-43
Cutting a Medium ...................................................... 2-44