MIMAKI CJV300-160 - Chapter 1 Before Use

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.3 P.10
4.3 Mounting the Accessories
R.1.0
1
2
3
4
5
6
7
6. Attach the tank trim plate to the right leg with the 2 screws
(M5x15).
7. Attach the angular waste ink tank.
Insert the angular waste ink tank.
8. Close the tank stopper.
Put a hook of the tank stopper in a hole of the printer then lock
it.
Tank trim plate
Hole
Angular waste ink tank
 The waste ink tank is stowed in the maintenance
space.
 It will be easier to remove the waste ink tank if
you turn its left side around to the front.
INSTALLATION GUIDE > Printer Assembly > Mounting the Accessories
Model CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
Rev.