Mimosa B11 User Manual

B11 User Guide
Mimosa Networks Help Site Management
Copyright © 2015 Mimosa Page 41
Enabling Watchdog
The Watchdog panel contains controls to monitor a remote host and reboot the local device under configurable
failure conditions.
IP Ping Watchdog - Enables the IP Ping Watchdog feature, which resets the device if it cannot ping a certain IP
●
after a number of retry attempts.
Ping IP Address - Enter the IP address of the device to ping.
●
Interval - Set the number of seconds (1-3600) between ping attempts.
●
Delay After Startup - Set the delay in number of seconds (1-3600) between device start up and the first ping
●
attempt.
Failure Count Triggering Reboot - Set the number of failed ping attempts (1-100) before rebooting the device.
●
WARNING: rebooting will take the device offline.

Mimosa B11 Specifications

General

Channel Widths	20/40/80 MHz
Ingress Protection	IP67
Antenna Connector	Integrated
Operating Temperature	-30°C to 55°C
Power Method	Passive PoE
MIMO	2x2
Ethernet Ports	1 x 10/100/1000 Mbps
Power Supply	Passive PoE