Mimosa C5c User Manual

Mimosa C5/C5c Client Manual
Copyright © Mimosa. All rights reserved.
http://client.help.mimosa.co/
The information contained in this document is subject to change without notice.
This document contains proprietary information which is protected by copyright.
All rights are reserved. No part of this document may be photocopied, reproduced,
or translated to another language without the prior written consent of Mimosa.

Mimosa C5c Specifications

General

Antenna Connector	2x RP-SMA
Max Power Consumption	10W
Product Name	Mimosa C5c
Category	Wireless Access Point
Max Transmit Power	27 dBm
Frequency Band	5 GHz
Channel Bandwidth	20/40/80 MHz
Ingress Protection	IP55
Operating Temperature	-40 to +55° C (-40 to +131° F)
Wireless Protocol	802.11ac
Max Data Rate	867 Mbps
Operating Frequency	4900-6200 MHz
Ethernet Ports	1 x 10/100/1000 Mbps
Power Method	Passive PoE
MIMO	2x2
Power Supply	Passive PoE

Summary

Setup and IP Address

Default IP and Discovery

Explains default IP, discovery methods, and limitations like no CDP/LLDP support.

Reset Process

Local Device Reset

Step-by-step guide to restore the device to its factory state using the reset button.

Finding the Serial Number

Describes two methods to locate the 10-digit serial number on the radio.

Performance Metrics

SNR and EVM

Details SNR requirements for MCS and the meaning of Error Vector Magnitude (EVM).

Quality of Service (QoS)

Explains QoS queues and their prioritization values for traffic management.

Product Specifications

Receiver Sensitivity

Details receiver sensitivity in dBm by MCS index for different channel widths.

Power over Ethernet

Details voltage requirements and PoE compatibility for Mimosa radios.

Installation Guide

Installation Overview

Overview of C5 and C5c installation steps, including mounting and grounding.

Mounting and Grounding

Instructions for securely attaching and grounding the C5 radio.

Power & Data Connections

PoE Connections

Guides on connecting the PoE adapter to power source and the radio.

Client Setup

Preliminary Radio Setup

Steps for initial radio configuration prior to deployment, including firmware and naming.

General Overview

Compliance and Safety

Covers FCC, IC compliance, and RF exposure warnings.

User Interface

Accessing and Logging In

How to access the GUI via LAN/wireless and log in with password.

Dashboard Overview

Explains the Dashboard's panels for status, performance, and device details.

Wireless Configuration

Spectrum Analyzer and Channel Settings

Details reading the Spectrum Analyzer and managing channel settings.

Power Settings

Managing transmit power and AGC mode.

Link Settings

Device and Link Configuration

Covers device mode, protocols, rate limiting, and link settings.

Location and Site Survey

Coordinates and Site Survey

Setting coordinates and interpreting site survey results.

General and Management

Device Naming and Password

Setting device names, descriptions, and changing passwords.

Management IP and Services

Configuring management IP, services like HTTPS, and watchdog.

Notifications

SNMP and Syslog

Enabling and configuring SNMP and Syslog notifications.

Firmware & Reset

Firmware Update

Procedures for performing firmware updates.

Device Reset

Options for factory reset, configuration reset, and device reboot.

Configuration Management

Backup and Restore

How to back up and restore device configuration settings.

Diagnostic Tools

Ping and Traceroute

Explains and details how to perform Ping and Traceroute tests.

Diagnostic Logs

How to view and download event logs for troubleshooting.

Troubleshooting

Ethernet and Association

Addresses Ethernet issues like port flapping and radio association failures.

Performance Issues

Covers troubleshooting for DHCP, SNR, PER, Tx/Rx power, and TCP throughput.