Mimosa B11 User Manual

B11 User Guide
Mimosa Networks Help Site Notifications
Copyright © 2015 Mimosa Page 53
Enabling System Log Notifications
Enable Syslog service on the local device to send traps to a remote Syslog server.
Syslog Remote Log - Enable or disable Syslog service on the local device.
●
Transport Server - Choose the desired protocol for the Syslog connection. Note that most devices send UDP
●
messages by default. UDP is an unreliable transmission protocol, thus messages may get lost. Choose TCP for
higher reliability if any message loss is unacceptable.
Remote Log IP Address - List the IP Address of the remote Syslog server to which Notifications will be sent.
●
Remote Log Port - List the Port on the remote Syslog server to which Notifications will be sent.
●

Mimosa B11 Specifications

General

Channel Widths	20/40/80 MHz
Ingress Protection	IP67
Antenna Connector	Integrated
Operating Temperature	-30°C to 55°C
Power Method	Passive PoE
MIMO	2x2
Ethernet Ports	1 x 10/100/1000 Mbps
Power Supply	Passive PoE