Mindray BS-200 User Manual

Preface
4
Safety Precautions
Observe the following safety precautions when using the BS-200 Chemistry Analyzer.
Ignoring any of these safety precautions may lead to personal injury or equipment
damage.
WARNING:
If the system is used in a manner not specified by Mindray, the
protection provided by the system may be impaired.
Preventing Electric Shock
Please observe the following instructions to prevent electric shock.
WARNING:
When the MAIN POWER is on, users must not open the rear cover or
side cover.
Liquid ingression may lead to electric shock or equipment damage. In
case of liquid ingression, shut off the power supply and contact
Mindray Service Department or your local distributor.
Preventing Personal Injury Caused by Moving Parts
Please observe the following instructions to prevent personal injury caused by
moving parts.
WARNING:
Do not touch such moving parts as probe and mixing bar, when the
system is in operation.
Do not put your finger or hand into any open part when the system is
in operation.
Preventing Personal Injury Caused by Photometer Lamp
Please observe the following instructions to prevent personal injury caused by
photometer lamp.
WARNING:
Light sent by the photometer lamp may hurt your eyes. Do not stare
into the lamp when the system is in operation.
If you want to replace the photometer lamp, first switch off the MAIN
POWER and then wait at least 30 minutes for the lamp to cool down
before touching it. Do not touch the lamp before it cools down, or you
may get burned.

Mindray BS-200 Specifications

General

Throughput	200 tests/hour
Wavelength Range	340-800 nm
Light Source	Halogen lamp
Absorbance Range	0-3.0 Abs
Measurement Principle	Photometric
Sample Capacity	40 positions
Reagent Capacity	40 positions
Reagent Positions	40 positions
Sample Positions	40 positions
Sample Volume	2-35 μL
Operating System	Windows-based
Power Requirements	AC 110-220V, 50/60 Hz
Reagent Volume	20 ~ 350 μL
Assay Types	Endpoint, Kinetic, Fixed-time