Mindray DP-8800plus User Manual

1
Schematic Plan for DP-8800plus/DP-8600 Part Installation
Figure 1 Schematic Plan of Part Installation (with 14” monitor)
1
2
3
45
6
7
8
9
Figure 2 14” Monitor Assembly
1. transducer holder C
2. transducer holder D
3. ultrasound gel holder
4. hexagon socket screw
M5×35/spring washer Φ5/plain
5. pushing handle
6. limit screw M5×16/spring washer
Φ5
7. transducer cable hook
8. screw M4×8
9. rear cover of monitor
10. screw M4×8
11. monitor assembly
12. neck cover
13. main unit
1.
limit screw
2.
cable strap
3.
screw M4×8
4.
rear cover of monitor
5.
power cable
6.
signal cable
7.
monitor
8.
friction pad
9.
neck cover

Mindray DP-8800plus Specifications

General

Gray Scale	256 levels
Frequency Range	2.0 - 10.0 MHz (depending on probe)
Imaging Modes	B, B/B, 4B, M
Scanning Mode	Electronic Convex, Electronic Linear
Probe Frequency	2.0 - 10.0 MHz (depending on probe)
Applications	Abdomen, Obstetrics, Gynecology, Cardiology, Small Parts, Urology, Vascular, Pediatrics
Supported Probes	Convex, Linear, Micro-convex
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler, Tissue Doppler Imaging
Power Supply	100-240V~ 50/60Hz

Summary

Installing the Monitor

Placing Neck Cover and Friction Pad

Place the neck cover on the main unit neck and the friction pad on the rotating axis.

Routing and Connecting Cables

Thread power and signal cables through the axis, connect them, and secure with a cable strap.

Installing Monitor Rear Cover

Install the rear cover of the monitor and tighten it with three M4X8 screws.

Securing Neck Cover

Fix the neck cover using M4X8 screws.

Tightening Limit Screw

Tighten the limit screw on the neck.

Removing Screen Protector

After installation, remove the protective film from the monitor screen.

Installing the Pushing Handle

Attaching Pushing Handle

Fix the pushing handle using hexagon socket screws, spring washers, and plain washers.

Installing Transducer Cable Hook and Holder

Positioning Hook and Holder

Take out and place the transducer cable hook and holder in their designated positions.

Installing the Transducer

Unlocking and Inserting Transducer

Unlock the transducer connector lever, lift the cable, and insert the connector vertically into the socket.

Securing Transducer Connector

Turn the lever clockwise by 90 degrees to ensure the connector is tightened.