Mindray DPM 6 - Invasive Blood Pressures; Adjust Invasive Blood Pressure Label

P/N: 046-003757-00 Rev A
Quick Reference Guide
6
Or
a. Select NIBP numeric tile, or enter the NIBP Setup >> from the Parameters
menu in Main Menu
(quick key) to enter the NIBP Setup menu
b. Select Interval and adjust value using up and down arrows
c. Select Main Menu
(quick key) or to return to the main display
To stop the current NIBP measurements on a patient on the DPM 6 or DPM 7
bedside monitor:
a. Select
on the front panel of the monitor or the Multi-Parameter
Module (MPM) during the NIBP measurement
To stop all NIBP measurements on a patient on the DPM 6 or DPM 7 bedside
monitor:
a. Select Stop all measurements
(quick key)
Or
a. Select NIBP numeric tile, or select NIBP Setup>> from the Parameters
menu in Main Menu
(quick key) to enter the NIBP Setup menu
b. Select Stop All
c. Select Main Menu
(quick key) or to return to the main display
INVASIVE BLOOD PRESSURES
The DPM 6 and DPM 7 monitors allow a clinician to monitor up to 8 invasive
blood pressures (IBP) simultaneously.
Adjust Invasive Blood Pressure Label
To adjust the label on an invasive blood pressure on the DPM 6 or DPM 7
bedside monitor:
a. Select displayed invasive blood pressure waveform or IBP numeric tile to
enter the Invasive blood pressure’s Setup menu
Or
a. Select the invasive blood pressure (ART, CVP, etc.) from the Parameters
menu in Main Menu
(quick key) to enter the invasive blood
pressure’s Setup menu
b. Select label and adjust the label using the use the up and down arrow
keys