Mindray iPM 10 - Changing the Screen Layout

8
Basic Operations
Area A
Changing the Screen Layout
You can enter the [Screen Setup] window as shown below by
selecting [Main Menu]
→
[Screen Setup]
→
[Screen Layout >>].
In this window, you can allocate the positions of the parameters and
waveforms. The parameters or waveforms whose positions are not
allocated will not be displayed.
The ECG parameter and the rst ECG waveform always display in the
rst row. The congurable areas can be classied as Area A, Area B,
and Area C.
In Area A, you can choose to display the parameters (having wave-
forms) and their waveforms. Each parameter and the associated wave-
form are displayed in the same row.
In Area B, you can choose to display the parameters and their wave-
forms. When there is no parameter displayed in area C, both the pa-
rameters and their waveforms will be displayed in area B. Otherwise,
only the parameters will be displayed.
In Area C, you can choose to display all the parameters whose associ-
ated waveforms will not be displayed.
The screen can automatically adjust to ensure the best view based
on your screen setup.
NOTE:
The parameters whose positions are not allocated in the
[Screen Setup] window will not be displayed. However, the
monitor can still give alarms of these parameters.




The monitor provides the following screens:
Normal Screen, or

Big Numerics Screen, or

Minitrends Screen, or

OxyCRG Screen, or

PAWP Screen, or

C.O. Screen, or

View Others Screen, or

ECG 7-Lead Half-Screen, or

ECG 7-Lead Full-Screen,or

ECG 12-Lead Full-Screen

You can select [Main Menu]
→
[Screen Layout>>]
→
[Choose
Screen] to choose a desired screen.
Area C
Area B