Monitor Mode: The monitor will automatically enter monitor mode after powers on.
Monitor mode is a common mode for monitoring patient vital signs.
Spot Check Mode: The spot mode is intended for on-spot measurement in a short
period. When spot mode is ON, the message area will display [Spot Check] on the top
of screen.
To enter Spot Check mode, select [Main]
→
[Maintanence>>]
→
[User Settings>>]
→
Enter required password
→
Set [Spot Check] to [ON].
Standby Mode: In standby mode, the monitoring for current patient is over, but the
monitor still powers on.
To enter Standby Mode, press the power button. Then a warning pops up. Select [Yes]
to enter Standby mode.
Demo Mode: Demo mode is password protected, and it is used for demonstration
purpose only.
To enter Demo mode, select [Main]
→
[Maintenance>>]
→
[Demo>>]
→
Enter required
password
→
Select [OK].
VS-900 Vital Signs Monitor Quick Guide
This is a Quick Guide. Refer to VS-900 Operator's Manual (PN:046-004883-00) for details.
Power ON/OFF Switch
Press this key to turn the monitor on.
Press this key to enter/exit Standby mode.
When the monitor is on, press and hold this
key for above 2 seconds to turn the monitor
o.
Alarm Reset Key
Press this key to disable the audio of present
alarms.
Press and hold this key for more than 2
seconds to pause or restore alarms.
NIBP Start/Stop Key
Press to start or stop NIBP measurements.
Admit Patient Key
Press this key to admit a new patient.
Press this key to return to main screen.
Knob
Rotate the knob clockwise or anti-clockwise to
move the cursor.
Press the knob to select one item, such as
accessing a menu or conrming the selection.
Interfaces and Menu
Side Connectors and Recorder
Rear View
NIBP connector
SpO
2
connector
Recorder
Start/Stop key
AC power
input
Equipotential
grounding
terminal
Network
connector
Multi-
function
connector
Temp
probe
connector
USB
connector
Operating Modes
Keys and Functions
!
CO
2
sample line
Connector
CO
2
gas outlet
To Previous Page
Loading...
Need help?
General
