Minebea Intec MiNexx-link-E PR 5215/10 - RS-485 Interface Specifications

4. Device installation | 4.3 - Hardware construction | 34
Technical data (continued)
Description Data
Transfer rate 10Mbit/s, 100Mbit/s, full/half duplex, auto-detec
tion
Default IP address 192.198.0.100, DHCP is switched on
Subnet Mask 255.255.255.0
Connection mode Point to point
Potential isolation yes
Cable type CAT 5 patch cable, twisted pair, screened
Cable impedance 150Ω
Cable length max. 115m
4.3.2 RS-485 interface
The device is equipped with an integrated RS-485 interface. The interface can
be configured by software.
The connection diagram is located on the right side of the housing.
Technical data
Description Data
External Connection 4-pin plug connector
Number of channels 1
Type RS-485, full duplex
Transfer rate [Bit/s] 300, 600, 1200, 2400, 4800, <9600>, 19200