2 Safety instructions
2.1 General notes
NOTICE
Warning of damage to property and/or the environment.
The product was in perfect condition with regard to safety features when it left the
factory.
To maintain this condition and to ensure safe operation, the user must follow the
instructions and observe the warnings in this manual.
2.2 Intended use
The mounting kits PR 97/00, ../01 are intended for weighing tasks, and must only be used
as such.
The mounting kits PR 97/00, ../01 are designed for installing the load cells MP 77.
The dimensions of all mounting and structural components must be calculated so that
sucient overload capacity is ensured for all loads which may occur while taking the
relevant standards into account. In particular, upright weighing objects must be
safeguarded against the weighing installation turning over or being shifted, thus
eliminating danger to people, animals, or goods even in the case of a break in a load cell
or mounting element.
Installation and repair work must only be carried out by expert/qualied personnel.
The mounting kits reect the state of the art. The manufacturer does not accept any
liability for damage caused by third-party system components or due to incorrect use of
the product.
2.3 Initial inspection
Check the contents of the consignment for completeness. Check the contents visually to
determine whether any damage has occurred during transport. If there are grounds for
rejection of the goods, a claim must be led with the carrier immediately. The
Minebea Intec sales or service organization must also be notied.
2.4 Before operational startup
NOTICE
Perform visual inspection.
Before operational startup as well as after storage or transport, inspect the
mounting kit visually for signs of mechanical damage.
Mounting kits PR 97/00, ../01 2 Safety instructions
EN-4 Minebea Intec
To Next Page
Loading...
Need help?
General
