196
18. Specifications
18-1. Analog specifications
Bridge power supply
DC10 V±0.5 V (5 V, 2.5 V) within 180 mA, with remote sensing
Applicable transducers Up to 6 pieces of strain gage applied transducers (350 ohm) can be
connectable.
Input sensitivity
0.2 μV/d or more (d= minimum scale)
Input range
-3.1 mV/V ~ 3.1 mV/V
Zero adjustment range
±2.5 mV/V
Non linearity
0.01 %F.S.
Influence due to
temperature change
Zero point
±0.2 μV/℃ (When the calibration is made at 0.2 μV/d or more of
the input sensitivity.)
Sensitivity
±0.000 8 %F.S./℃(Calibrated at 0.2 μV/d of input sensitivity or
more. )
Input noise
±0.2 μVp-p or less. (When the calibration is made at 0.2 μV/d or
more of the input sensitivity.)
Analog filter
Approx. 4 Hz (Approx. 2, 6, 8, and 10 Hz can be changed.)
A/D sampling
200 times/s (Changeable to 20 times/s.)
A/D internal resolution
24 bits
18-2. Specifications for digital
Load
display
Display range The accumulation value display range is from –9 999 999 9999 to
9 999 999 999, and accumulation times is from 0 to 999 999.
Display increment
1 (Changeable to 2, 5, 10, 20 or 50)
Display unit 7-segment green colored fluorescent display tube with character’s
height 11.55 mm, 7 digits
Over display
[-OL] display at minus over, [OL] display at plus over
AD value over display
[-OVF] display at minus over, [OVF] display at plus over
Sub
display
Display range Accumulation total display -19 999 999 ~ 99 999 999,
Accumulation times 0 ~ 999 999.
Display unit 7-segment green colored fluorescent display tube with character’s
height 5 mm , 18 digits
Display details OFF (Changeable: Brand / Accumulation times / Accumulation
value, Brand / Accumulation times / Last accumulated data, brand /
Last accumulated data / Accumulation value, Brand / Last
accumulated data / OK, Brand / Accumulation times / OK, Brand /
OK / Accumulation value, Brand / Near zero / Full, OK / Over /
Under, Brand / OK / Free fall, Brand / S1 / S2, brand / S1 / S3,
brand / S1 /S4, brand /S2 / S3, Brand / S2 / S4, brand / S3 / S4,
brand / OK, brand / Over / Under, Brand / Accumulation times,
Brand / Accumulation value or Brand / Last accumulated data)
Condition display STABLE, PRE.TARE, TARE, GROSS, NET, CZ, HOLD, ERROR,
Z-BAND OK/S0, F.FLOW/S1, M.FLOW/S2, D.FLOW/S3,
OVER/S4, UNDER, FULL
Display rate
4 times/s (Changeable: 20 times/s)
Decimal point display
Changeable: No display, 10
1
, 10
2
, 10
3
and 10
4
.
Unit display
Changeable: No display, g, kg, t , N, kN or lb
To Next Page
Loading...
