52
CONTENTS
General Troubleshooting (Continued)
Master Vibration is turned On, but there is no vibration
1. Check that Master Vibration is turned On�
2. Check that Vibration is turned On for at least one Tone Region�
Detector is charging and the Charge Status LED is flashing, but the charge indicator is missing in the Status Bar
1. Check that you are charging from a USB charging source with a 2 A @ 5 V charging capacity�
2. If charging from a lower-powered USB port (such as a laptop port), the detector may be discharging the battery at
a faster rate than it is charging� This prevents the charge indicator from appearing� Try charging with the detector
switched off�
3. Avoid using a USB extension cable when charging�
Speaker is squeaky or muffled after submersion in cold water
1. Allow up to 30 minutes for the detector internal air pressure to return to normal� Note, laying the detector on the
ground with the Control Pod standing up may equalise internal air pressure faster�
Headphone indicator is On, but no headphones are connected
There may be water inside the Headphone Socket causing false detection of wired headphones�
1. Check that the Headphone Socket is clear of water and obstructions�
2. If water is present, use a warm (not hot) air dryer to dry the Socket�
To Next Page
Loading...
