Minelab Excalibur II User Manual

2 Heading Head-
ing Heading
Quick Start
Discriminate Mode: (For detecting non-ferrous metals)
Ensure that the battery pack is fully charged. (pg. 14)
Set the mode switch to Disc (Discriminate). (pg. 27)
Turn the detector 'On' by turning the Threshold control
clockwise until it 'clicks'. Continue turning until the audio
tone becomes 'just' audible. (pg. 22)
Set the desired position of the Discriminate control. (pg. 28)
Set the Sensitivity control to Auto or at the maximum
manual setting without electrical interference. (pg. 25)
You are now ready to start searching!
Pinpoint/All Metals Mode: (For detecting all types
of metals)
Ensure that the battery pack is fully charged. (pg. 14)
Set the mode switch to Pinpoint/All Metals. (pg. 27)
Turn the detector 'On' by turning the Threshold control
clockwise until it 'clicks'. Continue turning until the audio
tone becomes 'just' audible. (pg. 22)
Set the Sensitivity control to Auto or at the maximum
manual setting without electrical interference. (pg. 25)
You are now ready to start searching!
Instruction Manual

Minelab Excalibur II Specifications

General

Technology	Broad Band Spectrum (BBS)
Battery	Rechargeable NiMH battery pack
Operating Frequency	1.5 kHz - 25.5 kHz
Waterproof Depth	200 ft (66 m)
Weight	5.2 lbs (2.36 kg)
Coil Size	10-inch
Ground Balance	Automatic
Operating Modes	Discriminate
Battery Life	12 hours