Need help?Do you have a question about the Minelab EQUINOX 800 and is the answer not in the manual?
General| Operating Frequency | Multi-IQ, 5 kHz, 10 kHz, 15 kHz, 20 kHz, 40 kHz |
|---|---|
| Search Modes | Park, Field, Beach, Gold |
| Waterproof | Yes |
| Weight | 1.34 kg (2.96 lbs) |
| Battery Life | Up to 12 hours |
| Wireless Connectivity | Bluetooth |
| Battery | Lithium-ion rechargeable |
| Display | Monochrome LCD |
| Audio Output | Built-in speaker |
| Intended Use | Coin, Relic, Jewellery, Gold Prospecting |
| Target ID | 0-40 |
| Length | 1440 mm (56.7") |
| Coil | 11" Double-D |
| Headphones | Wireless (included) |
| Operating Temperature | −10°C to +40°C (+14°F to +104°F) |
| Charging Time | 4 hours |
| Waterproof Rating | IP68 (up to 10 feet / 3 meters) |
How to charge the EQUINOX detector's internal battery using a USB cable.
How to power on the EQUINOX detector.
Guide to choosing the appropriate detection mode for your location.
Instructions for performing an Auto Noise Cancel for optimal performance.
Final step to start detecting after initial setup.
Correct coil movement technique for effective target detection.
Step-by-step method for manually locating a target.
Detailed steps for safely and effectively recovering a detected target.
Advice on selecting the optimal detection mode for various environments.
Details for the Park detection mode, ideal for high-trash areas.
Details for the Field detection mode, suited for historical sites and varying targets.
Details for the Beach detection mode, optimized for salty and wet conditions.
Details for the Gold detection mode, for prospecting in mineralised ground.
Explanation of Minelab's simultaneous multi-frequency technology.
Steps to customize target acceptance and rejection settings.
Procedure to save current detector settings for quick access.
How to recall saved detector settings using the User Profile feature.
How to adjust the sensitivity level for optimal detection.
Steps to use the Pinpoint function for precise target location.
Procedure for the detector to automatically find the optimal noise cancel channel.
Procedure for the detector to automatically set ground balance.
How to control the overall loudness of detector sounds.
How to set individual volume levels for different tone regions.
How to adjust the pitch of the threshold tone for comfortable hearing.
How to choose between 1, 2, 5, or 50 audio tones.
How to adjust the pitch for specific tone regions.
How to adjust tone pitch specifically when using 50 tones.
Steps to create custom target discrimination patterns.
How to adjust the end position of tone regions.
How to adjust recovery speed for target separation.
How to adjust the detector's bias towards identifying targets as iron.
Comparison of latency for different wireless audio technologies.
Details on pairing, charging, and using the WM 08 module.
To Next Page
