EasyManua.ls Logo

Minelab EQUINOX 800 - Audio Options; Wireless Audio Latency

Minelab EQUINOX 800
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Wi-Stream Technology
Wi-Stream uses efficient low-power
digital audio transmission to achieve the
non-perceivable audio time lag of 17 ms
between EQUINOX and the WM 08 Wireless
Module.
For the fastest possible wireless audio, use
the WM 08 Wireless Audio Module*.
Audio Options
EQUINOX has both wired and wireless audio options to choose from.
Wireless Audio Latency
Each EQUINOX compatible wireless technology has a slightly different latency, or delay.
When metal detecting, the lowest latency is best.
When the coil is moving across the ground, any delay (latency) of the audio signal means that the coil will have moved past the target that
produced that audio. Low latency (less audio delay) causes targets to be detected closer to where they really lie in the ground. This is very
evident when swinging a coil left and right across a target. A higher latency will mean that the target is perceived to be in two locations
either side of the actual location. A lower latency will minimise this effect.
aptX™ Low Latency Technology
aptX™ Low Latency technology is faster
than standard Bluetooth, with a delay of
40 ms, giving a faster detection response.
Minelab ML 80* headphones use aptX™
Low Latency technology, and will deliver
faster audio than standard Bluetooth®
headphones.
Bluetooth® Technology
Any standard Bluetooth® headphones or
earbuds can be used with an EQUINOX
Series detector.
However, Bluetooth® technology has a
high audio latency of 100 ms.
This can make it difficult to visualise the
exact position of a buried target if you are
detecting with a fast swing rate.
Wireless Audio Wired Headphones
3.5 mm (1/8-inch) headphones
ML 80 and other Wireless
Bluetooth® aptX™ Low Latency
headphones
WM 08 Wireless Audio Module
3.5 mm (1/8-inch) headphones required
Other Bluetooth® headphones
Waterproof headphones
Minelab 3.5 mm (1/8-inch)
6.35 mm (¼-inch) headphones
Adaptor required
Speaker
Wireless Audio can not be used if the control unit is submerged. EQUINOX waterproof wired headphones are required for
underwater detecting. Submerging the coil only will not affect wireless audio operation.
There is a range of audio accessories
available. EQUINOX is also compatible with
most readily available headphones.
Audio Options | 54Contents

Other manuals for Minelab EQUINOX 800

Related product manuals