Control Panel
The EQUINOX control panel has a large monochrome LCD with a backlight, a keypad,
and side buttons. These display and control all of the detector functions.
LCD Screen
Large monochrome LCD with backlight.
Detect Mode Button
Scrolls through the Detect Modes: Park,
Field, Beach, Gold*.
Each Detect Mode has 2 customisable
Search Profiles.
Settings Button
A short press of the Settings button accesses
and scrolls through the Settings Menu.
A long press when in the Settings Menu
accesses Advanced Settings where available.
Charge Status LED
Shows the charge status of the detector
battery.
Power Button
Turns the power on/off, and is used for
Factory Reset.
Pinpoint/Detect Button
Press when in the Settings Menu to
return to the Detect Screen.
Press while detecting to activate
Pinpoint. Press again to return to the
Detect Screen.
Minus / Plus
Press when in the Detect Screen to
adjust the Sensitivity level.
Press when in the Settings Menu to
adjust the value of the selected setting.
Frequency Button
Select from the available frequency options:
Multi, 5 kHz, 10 kHz, 15 kHz, 20 kHz* and 40 kHz*.
Wireless Audio Button
Activate Bluetooth® or Wi-Stream to
connect wireless headphones or the
WM 08 wireless audio module.
Accept/Reject Button
Press when a detection occurs to reject the
detected Target ID. Rejected Target IDs will
not produce an audio signal when detected.
Use to create discrimination patterns and
adjust Tone Regions via the Settings Menu.
User Profile Button*
Saves the current detector settings for
future instant access.
All-Metal Button
Toggles between the current
discrimination pattern and All-Metal to
accept all targets.
Backlight Button
Turns the backlight on/off and
selects the backlight brightness*.
1. Remove the thin plastic film from the detector screen. Make
sure the screen is clean and free of dust and fingerprints.
2. Peel the backing off of the screen protector, being careful not
to touch the adhesive side.
3. Hold the edges of the screen protector, align it to the screen,
and apply gently.
4. Wipe any bubbles to the edge with a soft, clean cloth.
5. Peel off the front layer.
Applying a screen protector will protect your screen against
scuffing and scratching from normal use.
Additionally, the screen protector includes a text guide to help you
learn the top level settings in the Settings Menu.
Screen Protector Application
For screen protectors in languages
you will not use, cut the black section
off carefully with sharp scissors, and
then apply as usual.
Control Panel | 9Contents
To Next Page
Loading...
