Minelab EQUINOX 800 - ML 80 Factory Reset

ML80 Factory Reset
Factory Reset will return the headphones to factory presets, and
will unpair all paired wireless devices.
1. Turn the headphones off.
2. Press and hold the Multi-Function button for approximately 10
seconds, until the headphones beep twice and the Status LED
flashes pink.
3. Release the button. The headphones will now be in pairing
mode with the LED indicator flashing blue and red.
Charging ML80 Headphones
Going detecting with fully charged headphones is
recommended.
ML 80 headphones have an internal Lithium-ion battery.
1. Connect the supplied charging cable to the USB socket in the
headphones.
2. Connect the other end of the cable to a powered USB-A port.
3. The Status LED will turn red and remain on during charging.
4. Once the battery is fully charged, the LED will turn off.
ML80 Auxiliary Cable
ML 80 headphones come with a non-waterproof detachable
auxiliary cable that connect to any standard 3.5 mm (1/8-inch)
headphone socket for wired operation.
Therefore you can continue detecting, even if the headphones
battery is flat, by connecting the cable from your headphones to
the headphone socket on the rear of the EQUINOX control unit.
This cable can also be used to connect the headphones to the
WM 08. WM 08 does not have a speaker and must be used with
wired headphones.
Smart Phone Call Functions
The ML 80 headphones can be paired with 2 devices at once, so
you can also pair them with your smart phone. However, when a
call is received it will interrupt the detecting audio.
Answer a Call
When a call is incoming, the ring tone will be heard via the
headphones. Press the Multi-Function button to accept the call.
Reject / Ignore a Call
To reject / ignore an incoming call, press and hold the Multi-
Function button for approximately 2 seconds until a beep is heard,
then release the button.
End a Call
Press the Multi-Function button to end a call.
Transfer a Call
Press the Multi-Function button for 1 second, until a beep is
heard, to transfer a call from the headphones to a smart phone.
Repeat this procedure to transfer a call from a smart phone to the
headphones.
Last Number Redialling From the Headphones
In standby mode, double press the Multi-Function button on the
headphones.
This function is only applicable to smart phones with Bluetooth®
hands-free. Functionality will vary depending upon the smart
phone model. Refer to your smart phone user guide for additional
information.
Smart Phone Music Functions
Once the ML 80 headphones have been paired to a smart phone,
the headphones buttons can be used to remotely control the
smart phone music functions.
If ML 80 headphones are connected to a phone that is playing
music, and then connected to the detector, the detector audio will
be automatically muted whilst the music is playing.
Play / Pause Music
Press the Multi-Function button to play music that is paused.
Press the Multi-Function button to pause music that is playing.
When music is playing, the Status LED is steady blue.
Next / Previous Track
Press and hold the Minus (–) button for 2 seconds to play the next
track.
Press and hold the Plus (+) button for 2 seconds to play the
previous track.
Adjusting the Volume
Press the Plus (+) button to increase the volume by one level.
When maximum volume is reached, there will be a high tone.
Press the Minus (–) button to decrease the volume by one level.
When minimum volume is reached, there will be a low tone.
ML80 Wireless Headphones | 57Contents