29
CONTENTS
The Tone Volume setting allows you to set a
different volume level for each Tone Region�
This is a useful feature when detecting in iron
infested locations�
Tone Volume adjustment is local; only the current Search
Mode Search Profile is affected by changes to this setting�
The Tone Volume setting has a default setting of 25 for
non-ferrous tones, and a reduced volume for ferrous tones
depending on the selected Search Mode�
Tone Volume is not available for Gold* Mode, or
when Target Tone is set to 1 Tone�
The number of Tone Regions is defined by the Target Tone
setting, up to a maximum of 5 Tone Regions� Read "Change
the Number of Target Tones" on page 33 for more
information�
t1
t2
t1
t2
t3
t5
t4
Tone Volume adjustment screen for
Tone Region 1 (t1) when Target Tone
is set to 2� The Discrimination Scale
is divided into 2 regions�
Tone Volume adjustment screen for
Tone Region 1 (t1) when Target Tone
is set to 5� The Discrimination Scale
is divided into 5 regions�
ADJUST TONE VOLUME
Before adjusting Tone Volume, select your
preferred Target Tones setting (page 33)�
This is because changes to Tone Volume only apply
to the active Target Tone setting�
Note: only the ferrous tone (t1) can be adjusted on
the EQUINOX 700�
1. Press the Settings button to navigate to the Volume
Adjust setting�
2. Long-press (2 seconds) the Settings button to select
the Tone Volume Advanced Setting�
(2 Seconds)
3. The Frequency Display will indicate the Tone Region
that is currently selected (e�g� t1) and the Tone Region
segments on the Discrimination Scale will be On�
Press the Minus (–) or Plus (+) buttons to adjust the
volume of the selected Tone Region�
4. Press the Accept/Reject button again to advance to the
next Tone Region�
5. Repeat until all Tone Regions have been adjusted�
In trashy or iron infested locations, set the Tone
Volume of the ferrous Tone Region to be just-
audible, and then increase the volume of the Tone
Regions where your preferred targets will appear, in
order to emphasise them�
This way, you can hear how much ferrous trash is being
detected� If you hear lots of ferrous trash, detect more
slowly so you don't miss desired targets� If you hear very
little ferrous trash, you can detect more quickly�
Tone Volume (Advanced Setting)
* EQUINOX 900 only
To Next Page
Loading...
Need help?
General
