Minelab EXPLORER II - Assembling the Detector

THE MINELAB EXPLORER II
18
www.minelab.com
ASSEMBLING THE DETECTOR
ASSEMBLING THE DETECTOR
Handle assembly
Shaft assembly
Search coil
Please follow these instructions to assemble the Explorer II. Refer to
the drawings to identify parts and how they are positioned. The
detector’s components are organized into three categories:
• the search coil;
• the shaft assembly, made up of the upper shaft and lower
shaft;
• the handle assembly, made up of the handle, armrest and
control box.
NOTE To avoid difficulties or damage to the detector’s
electronic components, it is strongly recommended you
follow the sequence of instructions for assembly.
Please contact your Minelab dealer for further instructions should
any difficulties arise.
P0591-A