Field Guide
The exact location of a target can
be located by using
p i n p o i n t.
1 Once the approximate target location is
known, move the coil away from that area and
press
p i n p o i n t.
2 Sweep the coil slowly over the target location.
3 Taking note of the response, reduce the span
of each successive pass of the coil until you are
confident of the location of the target. Make a
mental note of the position or, mark a line on
the soil with your shoe or a digging tool.
4 Move to one side so that you can pass the coil
over the target at right angles to your initial
direction. When the detector sounds you
should know exactly where to dig.
To Next Page
