TIGHTEN CAMLOCKS
Tighten the Camlocks if they slip or become loose.
Open CloseTighten gently
in increments
Check and repeat
if needed
USB-AUSB-C
CHARGING
3 HOURS
CAUTION: Only charge the detector in ambient temperatures
between 0°C and +40°C.
CAUTION: Charge your detector with a good-quality USB charger
that has a minimum charging capacity of 2 A @ 5 V. Risk of USB
charger failure if a low-quality charger is used.
Look for the following marks on USB chargers:
7–8 HOURS
3
5
2
6
1
4
Frequency
Large Metal
Overload
ASSEMBLY
CONTROLS & DISPLAY
Target ID Number
Power
SETTINGS MENU
Press from the Detect Screen
to open the Settings menu.
Battery Level/Charging
Light Sensor
Wireless Audio
Headphones Connectivity
Action Bar
Actions/icons change
depending on settings
or the current screen
Sensitivity
Press / from the
Detect Screen to
adjust Sensitivity
Navigation Arrows (×4)
Action Bar
Soft Keys (×2)
Search Mode
Charge Status LED
ID MAP
General Settings
Frequency
Audio Theme
Target Tones
Ferrous Tones
Ferrous Limits
Discrimination Pattern
Recovery Speed
Ground Balance
Noise Cancel
Search Mode
Volume
Target Depth Indicator
Salt Indicator
(Beach Modes only)
Conductive ID with
Ferrous Indicator
Conductive ID
Tracking Ground Balance
Flashlight
Side Soft Key
Wireless Audio On/Off
Pinpoint
Press from the
Detect Screen to
toggle Pinpoint mode
Backlight/Lighting
Back
0
Target Trace
(e.g. nail)
Target Trace
(e.g. coin)
Ferrous
Limits
Discrimination
Pattern
Target ID Scale
Conductivity
Less
Ferrous
99
More
Ferrous
More
Ferrous
Sensitivity Level
To Previous Page
Loading...
