6
CAUTION – Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to oper-
ate the equipment.
NOTE – This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
8. MAINTENANCE / CLEANING / STORAGE INSTRUCTIONS
Check battery charger for dirt, oil, battery corrosion, etc. Use a water and baking soda solution for cleaning corrosion. Wipe clean using a
dry cloth.
Check ring terminals for dirt, oil, and battery corrosion; then disconnect from battery posts and clean as necessary with water and baking
soda solution
and dry with a clean cloth.
When the charger is not in use, coil the power cord to prevent damage.
If power cord or plug becomes damaged, you may contact the Minn Kota Service Repair Department for service repair information. Otherwise, dis-
pose of the battery charger in compliance with local law. Damaged cords and plugs can cause electric shock or electrocution.
When storing the battery charger, store in a clean dry area.
WARNING – TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT PERFORM ANY SERVICING OTHER THAN THOSE CONTAINED IN THE
OPERATING INSTRUCTIONS.
Specifications:
Model Part No. System Volts Banks
Output per
Bank (amps)
Total Output
(amps) Input Cable Output Cable Size L x W x H
Weight
(lbs)
Input Current
(120VAC, 60Hz)
MK110 1821100 12 1 10 10 18AWG - 6' 16AWG - 6' 10-1/2" x 7-1/2" x 4" 10 2.5A
MK210 1822100 12 / 24 2 5 10 18AWG - 6' 16AWG - 6' 11-1/2" x 7-1/2" x 4" 11 2.5A
MK220 1822200 12 / 24 2 10 20 18AWG - 6' 16AWG - 6' 13-1/2" x 7-1/2" x 4" 15 4.4A
MK220S 1822206 12 / 24 2 10 20 18AWG - 8.5' 16AWG - 6' 13-1/2" x 7-1/2" x 4" 15 4.4A
MK315 1823150 12 / 24 / 36 3 5 15 18AWG - 6' 16AWG - 6' 12-1/2" x 7-1/2" x 4" 14 2.7A
MK330 1823300 12 / 24 / 36 3 10 30 18AWG - 6' 16AWG - 6' 16-1/4" x 7-1/2" x 4" 20 5.2A
MK330S 1823306 12 / 24 / 36 3 10 30 18AWG - 8.5' 16AWG - 6' 16-1/4" x 7-1/2" x 4" 20 5.2A
To Next Page
Loading...
Need help?
General
